SRE (slip ring end) Delco 10SI / 12SI alternator casing

- precision die cast and machined alternator casting (back)
- our Delco 10SI / 12SI bearing and shaft kit provides the standard
   Torrington needle bearing required for this casing (see listing)
- standard Delco 10SI / 12SI rectifier fits this casing (see listing)


 Note: when the excitation coil in rotor is replaced by an NdFeB permanent
           magnet, slip rings are no longer necessary.  PMA’s are simple. When the
           permanent magnet rotor turns, rectified DC comes out. The voltage
           relationship with speed is linear.

 Note: if front casing(with bearing) is purchased, the cost of the front bearing will
           be deducted from the cost of the bearing and shaft kit.